Anti-Slip Coatings in Baton Rouge

How a Signature anti-slip coatings install runs.

Four steps, no subcontractors, no surprise change orders. The crew that quotes the job is the crew on site for the install. Connor is reachable by phone the entire project.

Step 1: walkthrough and scope. Connor or a senior installer evaluates slab condition, moisture, existing coatings, drainage, and the use case the floor needs to survive. You leave with a written scope and a fixed quote, not a vague range.

Step 2: prep, grind, and repair. Diamond grinding, shot blasting, crack chase and fill, joint repair, and full moisture mitigation when the slab calls for it. Eighty percent of every coating failure traces back to bad prep, and we do not skip steps to hit a price point.

Step 3: install. The full anti-slip coatings system is installed by Signature employees on a fixed schedule.

Step 4: final coat and walk through. Sealed, inspected, signed off, written warranty in your hand, crew off site on the day promised.

The grit itself is a real specification, not an afterthought. We broadcast aluminum oxide or silica aggregate into the wet topcoat at a measured rate, and the mesh size is chosen for the traffic: fine grit for barefoot pool surrounds, medium for commercial entries and ramps, coarse for loading docks and wash bays where boots and wheels need absolute purchase. Too coarse in the wrong place shreds mop heads and bare feet; too fine defeats the purpose. Matching mesh to use is most of the skill.

Slip resistance is measurable, and for commercial owners we spec to it. Insurance carriers and safety officers increasingly ask for a documented coefficient of friction on wet surfaces, and our systems hit the marks used in kitchen, healthcare, and industrial settings. The data sheets that support a claim defense come with the bid.

Louisiana adds its own argument for the system: afternoon storms mean every entry, ramp, and exterior slab spends half the year wet. The difference between a gritted and a smooth topcoat shows up in incident reports, and retrofitting grit onto an existing coated floor is a one-day job we do often, roughing the surface, broadcasting into a fresh clear coat, and handing back a floor that grips.

Maintenance stays simple with the right technique: a soft-bristle deck brush or autoscrubber with a pad the grit cannot eat, neutral cleaner, and a rinse. We put the routine on the care sheet so the floor keeps both its grip and its warranty.

Retrofit questions come up weekly: yes, grit can be added to an existing sound coating without redoing the system. The surface gets abraded for bond, a fresh clear goes down, and the aggregate broadcasts into it, one day of work in most cases, and the cheapest slip-and-fall insurance a wet-climate business can buy.

Where the slab is exterior, the clear is aliphatic so the finish will not amber, and where it is a kitchen or wash bay the grit pairs with chemistry rated for the cleaning protocol. The walk sorts the variables, and the quote names the mesh, the resin, and the traction target in writing.

Grit longevity is worth naming: broadcast aggregate locked under a quality clear wears with the coating rather than out of it, so the traction you buy at install is the traction you still have years in. Cheap paint-on grit additives shed within months, which is most of what gives the category a bad name.

Common questions about anti-slip coatings.

Direct answers from the Signature crew. If your question isn’t here, call (225) 456-9224 and we will work through it with you.